Sunbounce WIND-KILLER-STATIC Manual do Utilizador descarregar pdf

WIND-KILLER STATIC

Aufbauanleitung

Operating Instructions

Stand 2012/03/28

SUNBOUNCE.COM

Operating Instructions

1. The individual parts of the WIND-KILLER STATIC consist of a screen,

two bars (2-piece set), two tensioning cords and four pegs.

2. The rods must first be plugged together.

3. Thread each a pole on the left and right into the sleeves of the screen.

4. Make sure that the tips of the rods look out of the amplified corners at the

upper end of the sleeves.

5. Now pull each rubber which is attached to the D-ring at the other end of

the covering on the case over the tips of the rods. Thus, the covering is being

stretched tautly in a vertical direction.

6. Strip each of the loops, in the middle of the tensioning cords, over the

upper tips of the rods.

7. Now insert the lower end of each rod in the ground and tighten it with

using the stretch lines and the four pegs. Now your WIND-KILLER STATIC is

ready to use.

SUNBOUNCE GmbH · Buchenring 8 - 10 · 21272 Egestorf · Germany

Telefon: +49 (0) 4175 - 80 88 79 87 · Telefax: +49 (0) 4175 - 80 88 79 67

E-Mail: [email protected] · Internet: www.sunbounce.com

1 2

WIND-KILLER STATIC 1

Resumo do Conteúdo

Página 1 - WIND-KILLER STATIC

WIND-KILLER STATICAufbauanleitungOperating InstructionsStand 2012/03/28SUNBOUNCE.COMOperating Instructions1. The individual parts of the WIND-KILLER S

Página 2

1Bedienungsanleitung1. Die Einzelteile des WIND-KILLER STATIC bestehen aus einer Bespannung, zwei Stangen (2-teilig), zwei Spannschnüren und vier Heri

Comentários a estes Manuais

Sem comentários

Sunbounce WIND-KILLER-STATIC Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Acessórios Fotográficos Sunbounce WIND-KILLER-STATIC. SUNBOUNCE WIND-KILLER-STATIC Benutzerhandbuch Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais